Our technician touching up a dark timber wall panel in a hotel corridor

Before and after

OUR WORK.

Real repairs, photographed before and after on site. If you can still see where the damage was, we have not finished.

Drag to compare

CHIPPED STONE EDGE, REBUILT.

A chip broke out of the front edge of a stone benchtop beside the sink. We rebuilt the edge, re-profiled it and carried the veining through the repair. Drag the handle to see it before and after.

Chipped stone benchtop edge beside a sink after the repair

Chipped stone benchtop edge beside a sink before the repair

Documented jobs

BEFORE & AFTER.

Before

After

Blown-out melamine in a locker

The white melamine on the underside of a locker top panel had broken away and the board core was showing. We filled it, sanded it flush and re-finished it so the inside reads as new.

Before

After

Torn-out hinge fixing

A hinge plate had pulled out of the panel and taken the board and the finish with it. We rebuilt the fixing point so the hinge holds again and made good the surface around it.

Before

After

Chipped panel edge in a cupboard

The white panel edge had torn away where it meets the timber frame, back to raw board. We rebuilt the edge, re-profiled it and colour matched it into the surrounding white.

Before

After

Chipped base of curved joinery

The bottom edge of a curved seat base had been knocked through to the core. We rebuilt it around the curve and colour matched it so the line runs unbroken.

Before

After

Stained stainless steel cowl

An external stainless steel cowl was discoloured, stained and marked with white deposits. We cut it back and re-finished it to an even brushed surface.

Before

After

Rust runs on an external capping

Rust was bleeding down a white external capping. We drew the staining out and re-finished the surface evenly across the full run.

Before

After

Over-cut hole around a waste pipe

The opening around a waste pipe had been cut too large and left ragged and open. We closed it back up around the pipe and finished it flush with the panel.

Before

After

Made good around a wall cut-out

A rough opening had been cut into the wall for a switch plate and the plaster was broken back around it. We made good around the fitting and blended it into the wall finish.

Before

After

Chipped door edge

The MDF core along the bottom edge of a hinged door was damaged. We re-profiled the edge and colour matched it back into the finish.

Before

After

Gouge on a cabinet face

A deep gouge in the middle of a flat white cabinet door. We filled it in stages, sanded it flush and colour matched it to the finish around it.

Before

After

Chipped wall

Chips and knocks through the paint on a wall. We filled them, sanded them flush and colour matched them into the surrounding finish.

Before

After

Chipped stone bench top edge

A chip had broken out of the front edge of a stone bench top beside the sink. We rebuilt the edge, re-profiled it and carried the veining through the repair.

Before

After

Redundant tap hole in marble

A core-drilled tap hole that was no longer needed. We filled it flush and drew the marble veining back across it.

Before

After

Chipped stone wall panel

A chip through to the white substrate on the edge of a dark stone panel where it meets timber joinery. We filled it and colour matched it into the stone.

On site